Panasonic RQT9223 - Manual (Page 34)

34
RQT9223
Using the sound menu
 Sound menu items
The display shown below indicates the sound menu items. Refer to each section for details.
“CH LEVEL”
“DUAL” “DRCOMP” “W. S.” “EXIT”
“BASS” “TREBLE” “BALANCE”
(➔ below) (➔ below) (➔ below) (➔ page 35)
(➔ page 35) (➔ page 35) (➔ page 35)
Adjusting the speaker level
You can adjust the speaker levels of the center speaker, surround speakers, surround back
speakers and the subwoofer respectively.
1. Press [SOUND MENU] to enter the sound menu.
2. Press [e][r] to select “CH LEVEL ”, and press [OK] to confirm.
3. Press [e][r] to select a speaker to adjust, and press [OK] to
confirm.
How speakers are displayed
C : Center, LS : Surround left, RS : Surround right,
SBL : Surround back left, SBR : Surround back right,
SB : Surround back (If you connect one surround back speaker), SUBW : Subwoofer
4. Press [e][r] to adjust the level, and press [OK] to confirm.
Adjustment range:
C, LS, RS, SBL, SBR, SB (If you connect one surround back speaker);
–20 dB to +10 dB
SUBW;
--- , MIN, 1 to 29, MAX
Factory setting:
C, LS, RS, SBL, SBR, SB (If you connect one surround back speaker); 0 dB
SUBW; 20
5. Press [SOUND MENU] to select “EXIT ”, and press [OK] to
finish the setting.
Press [RETURN] to return to the previous display or to cancel the setup in the halfway.
Note
• Select “ --- ” to stop output from the subwoofer.
• Sound can be distorted if you raise the volume while the subwoofer level is high. Reduce
the subwoofer level if this occurs.
• When “MULTI CH PROCESSING” indicator is off, you cannot adjust speakers other than
the subwoofer.
Adjusting the bass
You can adjust the bass through this operation.
1. Press [SOUND MENU] to enter the sound menu.
2. Press [e][r] to select “BASS ”, and press [OK] to confirm.
3. Press [e][r] for adjustment, and press [OK] to confirm.
Adjustment range: -10 dB to +10 dB
Factory setting: 0 dB
4. Press [SOUND MENU] to select “EXIT ”, and press [OK] to
finish the setting.
Press [RETURN] to return to the previous display or to cancel the setup in the halfway.
Adjusting the treble
You can adjust the treble through this operation.
1. Press [SOUND MENU] to enter the sound menu.
2. Press [e][r] to select “TREBLE ”, and press [OK] to confirm.
3. Press [e][r] for adjustment, and press [OK] to confirm.
Adjustment range: –10 dB to +10 dB
Factory setting: 0 dB
4. Press [SOUND MENU] to select “EXIT ”, and press [OK] to
finish the setting.
Press [RETURN] to return to the previous display or to cancel the setup in the halfway.
TV/VIDEO
SUB MENU
S
ENTER
Note
• If you press buttons other
than [e][r][w][q], [OK] and
[RETURN] while setting the
sound menu, the sound menu
operation will stop. To continue
the operation, see pages 34
and 35.
SA-BX500-PP (RQT9223-Y)_En.indd 34 6/27/2008 4:06:09 PM