Panasonic RQT9223 - Manual (Page 53)

53
RQT9223
Error messages
Message Cause/countermeasure
1 U701
The equipment connected by the HDMI cable is not compatible with the unit’s copyright
protection technology.
2 U703
Should anything unusual happen using an HDMI connection:
Consult your dealer if the sign remains on the display after these steps.
• Turn the connected equipment off and on again.
• Pull out the HDMI cable then reinsert it.
• Reduce the number of equipment connected in series to the HDMI terminal if exceeding 2
units.
3 U704
The unit has received a signal for a picture format that is incompatible with the HDMI connection.
Check the settings of the connected equipment.
4
REMOTE 1
or
REMOTE 2
Match the modes on the main unit and the remote control.
5
CANCEL MUTING
FUNCTION Muting is on.
Press [MUTING] on the remote control to cancel the function (➔ page 31).
6
NO C AND LS/RS
SPEAKERS
Center and surround speakers are set as absent. Change their setting to present (➔ page 37).
7
NO LS/RS
SPEAKERS
Surround speakers are set as absent. Change their setting to present (➔ page 37).
8
NO LS/RS AND SBL/
SBR SPEAKERS Surround and surround back speakers are set as absent. Change their setting to present
(➔ page 37).
9
NO SBL/SBR
SPEAKERS
Surround back speakers are set as absent. Change their setting to present (➔ page 37).
10
NOT POSSIBLE FOR
ANALOG 8CH INPUT
You are trying to use the effect unavailable for analog 8-channel playback.
11
NOT POSSIBLE FOR
THIS INPUT SOURCE
You are trying to use the effect unavailable for the current input source.
12
PCM FIX
(flashing)
The unit is in the “PCM FIX” mode. Cancel this mode (➔ page 39).
13 SELECT SPEAKER A “SPEAKERS A” is off. Select “SPEAKERS A” (➔ page 26).
14 SPEAKERS ARE OFF
“SPEAKERS A” and “SPEAKERS B” are off. Select “SPEAKERS A” or “SPEAKERS B”
(➔ pages 26 and 27).
15
NOT SUPPORT FOR
THIS WIRELESS
SYSTEM
Not compatible with this wireless system (➔ page 23).
Glossar
y / Err
or messa
g
es
Ref
erence
SA-BX500-PP (RQT9223-Y)_En.indd 53 6/27/2008 4:06:48 PM