Additional information 15 – Pioneer DVR-640H-S User Manual
Page 129
Additional information
15
129
En
• There is no DV input or the input sig-
nal is unrecordable.
No signal was detected at the
DV IN
jack. This may
appear if a blank section of DV tape is playing in
the connected camcorder.
• HDD optimization is recommended.
This can be done using Disc Setup.
The HDD should be optimized (basically, HDD
housekeeping) to maintain playback and recording
performance.
• Please perform HDD optimization.
This can be done using Disc Setup.
The HDD is in more urgent need of optimization in
order to maintain performance.
• The HDD has not been sufficiently
optimized. Please optimize again.
If this message appears repeatedly after
optimizing the HDD it is likely that there is not
enough free space on the HDD for optimization to
complete properly. Please erase some titles from
the HDD and optimize again.
• This signal’s TV system is different
from the recorder’s setting.
The TV system (PAL, NTSC, etc.) of the current
channel is different from the TV system settings of
this recorder.
• Recording failed due to a TV system
mismatch. Press DISPLAY to clear mes-
sage.
The timer recording failed because the TV system
of the channel set for recording was different from
the setting of the recorder.
• Playback has stopped because the TV
system is different than the recording.
During recording or timer recording standby, the
TV System (PAL, NTSC, etc.) of the playback video
changed, causing playback to stop automatically.
No DV camcorder connected.
The camcorder is not connected properly, or the
camcorder is switched off.
You cannot connect more than one DV
camcorder at a time.
This recorder’s DV jack supports connection to
just one camcorder.
Cannot operate the DV camcorder.
This recorder cannot operate the DV camcorder.
Try switching off the camcorder then turn it back
on again.
Could not operate the DV camcorder.
This recorder was not able to operate the DV
camcorder.
The DV camcorder is not set for play-
back. Please select playback mode on
the DV camcorder.
The camcorder is in camera mode. Switch it to
playback mode.
Message
Explanation/Action
DVR640H_WPW_EN.book 129 ページ ２００６年４月１１日 火曜日 午前９時４４分