Planet Technology PL-101E - Manual (Page 13)

10
4. USB to Powerline Network Adapter Installation
4.1 Connecting USB to Powerline Network Adapter
1. Plug the other end of the USB cable into the computer’s USB port.
2. Plug the USB cable into the USB port on PL-101U.
3. Plug the power cord into the powerline port on PL-101U.
4. Plug the other end of the power cord into a power outlet.
Note!
Use only the supplied power cord to connect PL-101U to the power outlet.
Windows 95 and NT do not support the USB adapter.
Because PL-101U sends data over the powerline of your house, it is best to
plug PL-101U’s power cord directly into a power outlet. Do not plug PL-101U
into a UPS power strip with surge protection. PL-101U has its own power filter
for protection against surges.
All the Powerline devices must on the same electrical phase.
4.2 USB to Powerline Network Adapter Driver Installation
The installation procedure for the network driver will vary depending on which
operating system you are using on your computer. The following procedure is for
installation under Windows 98. Installation on other operation system is similar.
1. Windows will automatically detect the presence of the USB Adapter hardware in
your computer once you have completed the hardware installation. Click the Next
button.