Panasonic AG-DV2500P - Manual (Page 40)

E-40
RECORDING – Audio dubbing –
Memo
• During audio dubbing, if the tape comes to a part
recorded in a non dubbing-feasible mode (such
as LP mode or 48kHz audio mode), the VTR will
enter the STOP mode. When this happens, high-
volume noise from the DV output will occur.
Hence, before audio-dubbing, please check the
recording mode of the tape.
• In the case that a microphone is connected to
the MIC terminal, sound output from this termi-
nal will be recorded. In the absence of MIC input,
signals from the CH1/3, CH2/4 AUDIO IN termi-
nal on the rear panel will be recorded.
• When audio dubbing cannot be performed, an
alarm message will be displayed on the monitor.
(
☞
Page 23)
• Audio dubbing PAUSE cannot be executed di-
rectly in the STOP mode. Please execute it in the
STILL mode.
During audio dubbing pause, sound from the
CH3/CH4 channel is output via the monitor but
sound output from the DV terminal is not pos-
sible.
• If audio dubbing is repeated on a short section of
the tape, noise may occur for an instant when
the section is played.
• During audio dubbing, noise may be produced
on the playback video or playback sound but the
recording is normal.
• The playback sound of CH1/2 cannot be recorded
on CH3/4 (sound on sound).
• During backspace operation of audio dubbing,
audio dubbing cannot be performed on unre-
corded parts.
• When audio dubbing is performed on tapes re-
corded on other devices, it may not record cor-
rectly. Please record with this unit before perform-
ing audio dubbing.
Connection
Audio dubbing sounds are input from the AUDIO IN
terminal on the rear panel or the MIC terminal on
the front panel. MIC terminal prevail over the AU-
DIO IN terminal.
Setting
• Set the AUDIO item of the AUDIO/VIDEO menu
to “32K”.
• Do not set the INPUT switch on the front panel to
“DV”.
Operation
1.
Press the PLAY button to play the tape.
2.
At the position where you want to au-
dio dub, press the PAUSE button.
¥ The unit goes into the STILL mode.
3.
Hold down the A.DUB button and press
the PAUSE button.
¥ The unit goes into the audio dubbing pause
mode.
4.
Press the PAUSE button.
¥ Audio dubbing begins. Audio signals are
recorded on the CH3 and CH4 channel.
Ⅵ To stop audio dubbing temporarily, press
the PAUSE button.
5.
To end audio dubbing, press the STOP
button.