Panasonic AG-DV2500P - Manual (Page 57)

E-57
AUDIO/VIDEO menu
Items Setting Contents
AUDIO MODE
A.OUT AT
SEARCH
AUDIO OUT SEL
AUDIO OUT
LEV
SET UP
(NTSC)
PAGE BACK
ⅷ 48K
32K
ⅷ OFF
ON
ⅷ CH-1/2
MIX
CH-3/4
ATT
ⅷ NORM
ⅷ OFF
ON
Select the audio sampling frequency for recording:
48K
: Records at 48kHz. It records in the 2-channel stereo mode.
No audio dubbing.
32K : Records at 32kHz. It records in the 4-channel mode. To
perform audio dubbing on CH3 and CH4 later, use this set-
ting.
Memo
This setting is not required for DV signal input.
Use this menu item to enable/disable audio output from the AU-
DIO OUT terminal during a search:
OFF : No output.
ON
: Output.
Use this menu item to select the audio channel output from the
AUDIO OUT terminal when playing back tapes recorded in the
32K mode:
CH-1/2
: Outputs CH1 and CH2 audio.
MIX : Outputs mixed audio of CH1 and CH3 and mixed au-
dio of CH2 and CH4.
CH-3/4 : Outputs CH3 and CH4 audio.
Memo
This setting can also be selected from the AUDIO OUT SEL. but-
ton on the wireless remote controller.
Use this menu item to select the standard level for audio playback
output:
ATT
: Attenuates the output level to about 8dB. Use this setting
when playing tapes recorded on a VTR of which the stand-
ard level for PCM audio is full scale -12dB. The playback
level is decreased by 8dB.
NORM : Usually, this is selected.
Memo
This setting can also be selected with the AUDIO OUT LEV. button
on the wireless remote controller.
During recording
OFF : Select this when analog signals are input without setup.
ON
: Select this when analog signals are input with setup.
During playback
OFF : Setup is not applied to analog video signals (composite, S-VIDEO)
ON
: Setup is applied to analog video signals (composite, S-VIDEO)
Memo
• If dubbing is repeatedly done with the settings of the playback or
recording video signals differing from the setting here, the hue
and brightness of the video may turn out abnormal.
• A high level of knowledge pertaining to video signals is neces-
sary to set this menu. Generally, for DV camcorders, SETUP is
recorded on the tape as part of the video signals. Accordingly,
SETUP is normally set to “OFF”.
To use SETUP correctly, switch the setting according to the video
signals being used.
Return to the top MENU.
Memo
When it is set to the MIX
mode, noise may be pro-
duced. If this occurs,
please set it to CH-1/2 or
CH-3/4.