Pioneer ANH-P9R-BK - Manual (Page 28)

Further information under Dynamic navigation
with TMC on page 34.
• RESTRICTIONS
Provides options for avoiding motorways, ferries
or toll roads.
Selection can be made by turning the right
rotary control, and settings can be changed by
pressing the
NAVI/OK button.
Press the control for more than 2 seconds to
accept all settings and quit the menu.
Note
• Routes without motorways can only be calcu-
lated for short distances (up to 200 km).
Caution
When a route is calculated, the route and
voice guidance for the route is automatically
set. Also, for day or time traffic regulations,
only information about traffic regulations at
the time when the route was calculated is
shown. For example, if a street is open during
the morning only, but you arrive later, it would
be against the traffic regulations so you can-
not drive along the set route. When driving,
please follow the actual traffic signs. Also, the
system may not know some traffic regula-
tions.
Storing a specified destination in
the destination memory
It is not absolutely necessary to store a destina-
tion in the destination memory for route guid-
ance. It saves repeated manual entry, if the
destination is required at a later date.
Select
SAVE DESTINATION in the route menu
and press the NAVI/OK button to confirm.
Any name of your choice consisting of up to 14
characters can be entered for the specified
destination and then automatically stored in the
destination memory after pressing the
NAVI/OK
button for more than 2 seconds. See
Destination memory on page 38.
To store, the small check
✓ can also be selected
and the rotary stick briefly pressed.
If you do not wish to enter a name of your
choice, press and hold the
NAVI/OK button for
more than 2 seconds to store the address as
previously entered in the destination memory.
The last destination entered can be filled at any
position by turning the rotary stick. The memory
position is confirmed by briefly pressing the
NAVI/OK button.
A total of 50 destinations can be stored.
For final storage in the destination memory,
either route guidance must be started or the
program must be switched to new destination
entry by selection of
NEW DESTINATION .
Navigation
En 28
03
Section