Pioneer ANH-P9R-BK - Manual (Page 78)

Audio Adjustments
Using bass adjustment
You can adjust the cut-off frequency and the
bass level.
• In
FRT1 mode, bass adjustment affects only
the rear output: front output cannot be
adjusted.
1 Press AUDIO and then press BASS .
2 Select the desired frequency with
2/3.
Press
2 or 3 until the desired frequency
appears in the display.
40 — 63 — 100 — 160 (Hz)
3 Press
5 or ∞ to adjust the bass level.
Each press of
5 or ∞ increases or decreases
the bass level. +6 – –6 is displayed as the level is
increased or decreased.
Using treble adjustment
You can adjust the cut-off frequency and the
Treble level.
• In
FRT1 and FRT2 modes, treble adjustment
affects only the front output: rear output cannot
be adjusted.
1 Press AUDIO and then press TREBLE .
2 Select the desired frequency with
2/3.
Press
2 or 3 until the desired frequency
appears in the display.
2.5k — 4k — 6.3k — 10k (Hz)
3 Press
5 or ∞ to adjust the treble level.
Each press of
5 or ∞ increases or decreases
the treble level. +6 – –6 is displayed as the level is
increased or decreased.
Using loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press AUDIO and then press LOUD to select
the loudness mode.
Loudness level (e.g.,
MID ) appears in the dis-
play.
2 Press LOUD to turn the loudness on.
LOUDNESS ON appears in the display.
• Press LOUD again to turn loudness off.
3 Select the desired level with
2/3.
Press
2 or 3 until the desired level appears in
the display.
LOW — MID — HIGH
En 78
10
Section