Precor 776i - Manual (Page 27)

Treadmill: Changing Remote Control
Access 1.
Important: To affect this setting, the treadmill must be connected
to a computer and you will need to be familiar with CSAFE
commands.
When you enable this program, you can set a user’s speed and
incline through a computer software program which interfaces with
the CSAFE port on the treadmill.
The default factory setting is set to D I S A B L E D . To change this
setting, perform the following steps:
At the R E M O T E S P E E D C O N T R O L prompt, press OK. Use
the navigational arrow keys to alternate between the two
selections.
Setting Description
E N A B L E D Lets you set the speed and incline for individual users
and their selected program using CSAFE commands
through a computer connection.
D I S A B L E D Disconnects remote access so you cannot use the
remote capabilities of a CSAFE connection. You
would also use this setting when the treadmill is not
connected to a computer.
2. When you are ready, press OK to accept the displayed setting
and move to the next program. For other options, refer to the
table in Accessing Club Programming Mode and Changing the
Settings.
Product Owner's Manual: Club Features 25