Panasonic PV 20DF63 - Manual (Page 10)

10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected] 10
Initial Setup
(Ready to Play)
2 / 6 / 2003 THU 12 : 00PM
DST : ON
AUTO CLOCK SET
COMPLETED
SETT I NG : CH 1 0
PLEASE SET CLOCK BY
PRESS I NG ACT I ON KEY
AUTO CLOCK SET
I S I NCOMPLETE
Plug the unit power cord into an AC
wall outlet. 1
3
2
• If you use a cable box, turn it on and set it to the
Public Broadcasting Service (PBS) channel in your
time zone. If you use a DSS receiver, it must be
turned off.
Initial Setup (Ready to Play)
Please make all cable or antenna connections before powering on.
Press POWER* on the remote or unit.
The unit comes on and auto channel
and clock set starts.
Settings are made automatically. When
setup is done, this screen appears.
If AUTO CLOCK SET IS INCOMPLETE
screen appears, set the clock using MANUAL
CLOCK SET procedure on next page.
• Function buttons are inoperative during Initial Setup.
• Depending on conditions, Auto Clock Set may take
longer than 30 minutes. If so, press STOP to stop
setup and perform settings manually. (See page
12-13.)
Connections
For ANT./Cable
Connect the cable from Antenna/Cable to
the VHF/UHF terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on your cable box
to the VHF/UHF terminal on the unit with
a RF cable.
Overtightening “Nut type” RF coaxial cables
may damage jacks. Finger tighten only.
WARNING
IN from
ANT./CABLE
VHF/UHF
VHF/UHF
VHF/UHF
VHF/UHF
Cable TV
Converter Box
IN from
ANT./CABLE
Notes
PROCEEDING
AUTO CLOCK SET
CANCEL : PRESS STOP KEY
CH AUTO SET PROCEEDING