Panasonic AJ-D230HP - Manual (Page 20)

Time Code and User’s Bit
Setting the time code
1
Set the VTR to the menu mode.
(Set the LOCAL/MENU/REMOTE switch to the MENU position.)
2
Select the “TC PRESET” set-up menu item, and press the MODE (REW) button.
(See page 28)
3
Select the digit (flashing display) in which the change is to be made using the UP
(FF) and DOWN (STOP) buttons.
4
Press the DATA+ (PAUSE/STILL) button or DATA- (PLAY) button to change the
value.
5
Upon completion of the settings, press the SET (REC) button.
(The display returns to the regular menu screen.)
6
Press the SET (REC) button again.
(The settings are now stored in the memory, and the menu mode closes.)
7
Set the LOCAL/MENU/REMOTE switch to the LOCAL or REMOTE position.
<Notes>
The current time code value is displayed as the default setting.
When the RESET button is pressed, the setting is reset to “00:00:00:00.”
The time code cannot be set unless the “TC MODE” set-up menu item has been set to “P-
REC” or “P-FREE.” (See page 28)
If the MODE (REW) button is pressed without pressing the SET button upon completion of the
setting, the time code setting is canceled, and the display returns to the regular menu screen.
Setting the user’s bit
1
Set the VTR to the menu mode.
(Set the LOCAL/MENU/REMOTE switch to the MENU position.)
2
Select the “UB PRESET” set-up menu item, and press the MODE (REW) button.
(See page 28)
The remaining steps in the setting procedure are the same as for the time code.
20