Panasonic AJ-D230HP - Manual (Page 21)

Time Code and User’s Bit
Time code and user’s bit playback
1
Set the VTR to the STOP mode.
2
Set to TC or UB using the COUNTER button.
TC : The time code is displayed.
UB : The user’s bit is displayed.
When the time code can no longer be read, interpolation is provided by the control
signal if the COUNTER button is set to the CTL position.
3
Press the PLAY button.
Playback is commenced, and the time code appears on the display. When the “DISPLAY
SEL” set-up menu item is set to “TIME” or “T, STA,” the time code value is superimposed
onto the video signals which are output from the MONITOR OUT connector.
(See page 24)
<Notes>
The colon between the seconds and frames changes to a period while the drop frame time
code is being read.
If the time code signal is missing, interpolation is automatically provided by the CTL signal.
The display changes as shown below.
T R 0 0 : 0 7 : 0 4 : 2 4
The colon (” : ”) between the seconds and frames
changes to a period (" . “) in the drop frame mode.
appears when the time code signal
is missing (superimposed display only).
21