Panasonic AJ-D230HP - Manual (Page 24)

Set-up Menus
BASIC menu
Item Setting
No.
S u p e r i m p o s e d No. S u p e r i m p o s e d
d i s p l a y d i s p l a y
000 DISPLAY SEL 0000 OFF
0001 TIME
0002 T, STA
:
001 CHARA H-POS 0000 0
0001 1
:
0003 3
:
0007 7
002 CHARA V-POS 0000 0
0001 1
0003 3
:
0007 7
003 CHARA TYPE 0000 WHITE
0001 W/OUT
005 MENU INHIBIT 0000 OFF
0001 ON
Description of settings
This sets what is to be displayed for the superimpose
signals output from the MONITOR OUT connector.
0: No display
1: Only the time is displayed.
2: The time and operation mode are displayed.
This sets the horizontal position of the superimposed
characters (8 settings to choose from).
This sets the vertical position of the superimposed
characters (8 settings to choose from).
This selects the type of characters for the
superimposed display and menu display.
0: White characters appear on a black back ground.
1: White characters with black borders appear.
This selects whether or not the menu settings are to be
fixed.
0: The settings are not fixed.
1: The settings are fixed (and cannot be changed).
The underlined number and item are the factory settings.
<Notes>
.
While setting “CHARA H-POS”, “CHARA V-POS”, and “CHARA TYPE”, the counter display can be
viewed by holding down the MODE button, allowing you to check the settings. You can also use the
DATA+ and DATA– buttons while holding down the MODE button to adjust the values while you are
viewing them.
.
To set ON or OFF for the “MENU INHIBIT” item, first press the DATA+ or DATA– button while holding
down the MODE button, and then select the setting.
Continuously after performing the settings, press the SET button (REC button) to exit the menu. The
MENU INHIBIT setting takes effect starting with the next menu mode.
24