Panasonic AJ-D230HP - Manual (Page 25)

Set-up Menus
OPERATION menu
Item
No. S u p e r i m p o s e d
d
No.
d i s p l a y
y
1 0 0 LOCAL 0000
ENABLE 0001
1 0 1 TAPE TIMER 0000
0001
1 0 2 S/F/R EE SEL 0000
0001
1 0 3 WIDE MODE 0000
0001
0002
104 TAPE IN MODE 0000
0001
0002
0003
1 0 5 TAPE END 0000
MODE 0001
0002
0003
1 0 6 SERVO REF 0000
0001
Setting
S u p e r i m p o s e d
d
d i s p l a y
y
DISABLE
ST EJ
12H
24H
EE
TAPE
AUTO
WIDE
NORMAL
STOP
REW
PAUSE
PLAY
STOP This selects the operation which follows when the tape
REW has reached the end.
R E W E J 0: Stop
EJECT 1: Rewind
2: This rewinds the tape and ejects it upon completion
of rewinding.
3: Eject
AUTO
EXT
Description of settings
This selects the switches on the front panel which can
be operated in the remote control mode.
0: None of the switches can be operated.
1: Only the STOP and EJECT switches can be operated.
This selects the CTL counter display.
0: ±12-hour display
1: 24-hour display
This selects the EE/VV output during stop, fast
forwarding or rewinding.
0: EE is output.
1: VV is output.
This selects the WIDE mode.
0: Automatic detection.
1: The screen mode is forcibly treated as WIDE.
2: The screen mode is forcibly treated as NORMAL.
This selects the operation which follows when the
cassette is inserted.
0: STOP
1: Rewind
2: Play pause
3: Play
This selects the sync signals of the servo.
0: Synchronization with the input signals; if no input
signals are present, synchronization with the internal
signals.
1: During playback, synchronization with the SYNC IN
signals; i f t h e s e signals are not present,
synchronization with the internal signals.
(AUTO) VIDEO IN connector:
Synchronized playback is performed using standard video signals.
With non-standard video signals, the switching is performed in such a way that playback is
synchronized with the internal signals.
(EXT) SYNC IN connector:
Use standard signals as the SYNC signals.
Non-standard signals cannot be used. Use of the BB (black burst) signal is recommended.
When an out-of-sync state occurs due to SYNC signal switching or interruption
Set to the STOP EE mode or eject the cassette and then re-load it.
This makes it possible for the synchronization to be reset.
107 AUTO BACK 0000
OFF This selects whether to automatically reverse (auto
0001 ON back) the tape to achieve back-space assemble
recording.
0: No auto back
1: Auto back
The underlined number and item are the factory settings.
25