Pioneer 2010 NAVIGATION UPGRADE SD-CARD CNSD-130FM - Manual (Page 129)

7 Press MULTI-CONTROL up or down to
adjust the output level of the subwoofer.
Each time
MULTI-CONTROL is pressed up or
down, subwoofer level increases or decreases.
“+ 6” to “– 24” is displayed as the level is in-
creased or decreased.
Enhancing bass (Bass Booster)
You can enhance bass sounds that are often
muted by driving noise.
1 Display the “Audio Menu” screen.
= For details, refer to Displaying the
“Audio Menu” screen on page 126.
2 Turn MULTI-CONTROL to select
“Bass
Booster
”.
3 Press MULTI-CONTROL up or down to
select a desired level.
“0” to “+6” is displayed as the level is in-
creased or decreased.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, activate
HPF
(high pass filter). Only frequencies higher than
those in the selected range are output from
the front or rear speakers.
1 Display the “Audio Menu” screen.
= For details, refer to Displaying the
“Audio Menu” screen on page 126.
2 Turn MULTI-CONTROL to select
“HPF”.
3 Press the center of MULTI-CONTROL to
turn high pass filter on.
p To turn high pass filter off, press
MULTI-CONTROL again.
4 Press MULTI-CONTROL left or right to
select cut-off frequency.
Each time
MULTI-CONTROL is pressed left or
right, frequencies are selected in the following
order:
50 Hz
— 63 Hz — 80 Hz — 100 Hz —
125 Hz
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
p Settings are based on the FM tuner volume
level, which remains unchanged.
1 Compare the FM tuner volume level
with the level of the source you wish to ad-
just.
2 Display the
“Audio Menu” screen.
= For details, refer to Displaying the
“Audio Menu” screen on page 126.
3 Turn MULTI-CONTROL to select “SLA”.
En
129
Chapter
26
Customizing
pr
eferences
Customizing preferences