Parts – Pioneer CDX-FM673 User Manual

Page 21

Advertising
background image

Removing the Display Unit/

Enlever de I’afficheur

Insert the G that comes with the unit as
shown in the illustration. Turn it to the left
and then pull it towards you.

Insérer la pièce G fournie avec l’appareil
comme montré sur l’illustration. La tourner
vers la gauche puis la tirer vers soi.

English

Français

3

2

1

E

D

A

F

Tout d’abord, percer les trous d’installation
dans la console, etc.
• Avant de percer les trous dans la console,

s’assurer que l’on peut le faire sans dan-
ger et veiller à ne pas endommager les
câbles d’alimentation électrique.

• La profondeur minimale requise pour le

support de montage affleurant est de
20 mm.

Installing the Display Unit/Installation de l’afficheur

A

×

1

B

C

D

E

F

G

Ч

1

Ч

1

Ч

1

Ч

1

Ч

1

Ч

2

Parts for display unit mounting/

Pièces requises pour le montage de l’afficheur

Fasten the display unit with Velcro tape/

Fixer I’afficheur à I’aide d’une bande Velcro

Installation using the flush mounting bracket/

Installation au moyen du support du montage affleurant

• Thoroughly wipe off the surface before

affixing the Velcro tape.

• Obviously, it is very dangerous if the cord

gets tangled in the steering wheel, so
install the cord so that it cannot get in the
way.

• Essuyez soigneusement la surface avant

d’attacher le morceau de bande Velcro.

• Il est naturellment dangereux si le cordon

sera enchevêtré au volant de direction, et
il faudra donc installer le cordon de telle
façon qu’il ne soit pas pris.

English

Français

English

Français

Start by opening installation holes in the
console, etc.
• When opening holes in the console, etc.,

confirm that there is no object at the rear
of the console, and be careful not to cut
off the power supply cord.

• A minimum depth of 20 mm is required

for installation of the flush mounting
bracket.

Fit the D into the opening in the console,
etc., raise the claws of the D with a flat-
bladed screwdriver, and secure the bracket
in place.

Fit the E into the D (the top and bottom of
the holder are predetermined), then secure
it with F.

Pass the display unit (A) cord through the
hole in the holder, and fit the display unit
into the holder.

Engager la pièce D dans l’ouverture de la
console, etc., soulever les griffes de la pièce
D

au moyen d’un tournevis plat et assurer

de cette manière le maintien du support.

Engager la pièce E dans la pièce D (les
parties supérieure et inférieure du support
sont repérées) et assurer le maintien au
moyen de F.

Faire cheminer le cordon de l’afficheur (A)
à travers le trou du support puis engager
l’afficheur dans le support.

1

2

3

4

Velcro tape

Bande Velcro

Claws
Raise the claws.

Mâchoires
Soulevez les mâchoires.

Console, etc.

Console, etc.

110 – 111 mm

40 – 41 mm

Velcro tape

Bande Velcro

(Rough surface)

(Surface rugueuse)

(Soft surface)

(Surface douce)

Advertising