13 the initial setup menu, Using the initial setup menu, The initial setup menu – Pioneer DVR-531H-S User Manual

Page 92: The initial setup menu 13, Chapter 13

Advertising
background image

The Initial Setup menu

13

92

En

Chapter 13

The Initial Setup menu

Using the Initial Setup menu

The Initial Setup menu is where you can set various recorder options for sound, picture, language and so on.

Some settings can only be changed when the recorder is stopped. During playback or recording these settings are
grayed out in the Initial Setup menu.

Except for the Setup Navigator, menu screens are exited automatically after 20 minutes of inactivity.

Press HOME MENU and select ‘Initial Setup’.

In the table below, the default option is marked with a •.

Setting

Options

Explanation

Basic Settings

Clock Setting

Auto

Set the channel that broadcasts a clock signal and the clock will be set
automatically.

Manual •

If there is no channel that broadcasts a clock signal in your area, you
can set the time and date manually.

• The clock must be set in order to use timer recording.
• When using EPG data download, the clock is set automatically and this setting is unavailable. To be able to use this setting again, reset the unit
to its default settings.

Help Setting

On •

Switches on the automatic Help screens for GUI displays.

Off

Switches off the automatic Help screens for GUI displays. (Press

HELP

on the remote to manually display the Help screen.)

Setup Navigator

Start

Select to start the Setup Navigator. See also

Switching on and setting

up

on page 25

.

Tuner Settings

Auto Channel Setting

Antenna •

Select if you receive channels from an antenna. It takes a few
moments for the auto tuning to complete.

Cable

Select if you receive channels via cable. It takes a few moments for the
auto tuning to complete.

Manual CH Setting

Next Screen

Proceed to the next screen if you need to adjust any of the settings
made by auto tuning.
• Change channels using the

CH +/–

buttons.

• To skip the displayed channel (because there is no station assigned
to that channel), change the

Skip

setting to

On

.

• To manually fine tune the channel, change the

AFT

setting to

Off

then adjust the

Level

setting.

• Note that you can’t use the Auto Channel Setting or the skip feature (in the Manual Channel Setting) after completing the TV Guide setting.

Video Out Settings

Component Video Out

Interlace •

Select if your monitor/TV is not compatible with progressive-scan video.

Progressive

Select if your monitor/TV is progressive-scan compatible. Check the operating
instructions that came with your monitor/TV if you’re not sure.

DVR-530H_KU.book 92 ページ 2005年6月8日 水曜日 午前11時16分

Advertising
This manual is related to the following products: