Pioneer DVR-531H-S - Manual (Page 93)

The Initial Setup menu 13
93
En
Audio In Settings
External Audio Stereo • Select if the audio from the currently selected external input is stan-
dard stereo.
Dual Mono Select if each channel carries a separate soundtrack.
When the external audio is from the DV input, an audio subcode channel within the DV audio tells the recorder whether the audio is stereo or dual
mono. This has priority over the setting you make here.
Dual Mono Recording L • Select to record the left channel of an external dual mono source when
recording to DVD in Video mode, to HDD with HDD Recording Format
set to Video Mode On, or in
LPCM mode.
R As above, but for right channel recording.
When recording dual mono audio to DVD in VR mode (except in LPCM mode), or to HDD with HDD Recording Format set to Video Mode Off (except
in LPCM mode), both audio channels are recorded and you can switch to the one you want on playback.
DV Input Stereo 1 • Select to use the ‘live’ audio track (recorded during the video shoot)
from a camcorder that supports two stereo audio tracks.
Stereo 2 Select to use the overdubbed audio track from a camcorder that sup-
ports two stereo audio tracks.
Mix Select one of the three settings to use a mix of the two stereo audio
tracks.
Input Level (L1–L3) -6dB – +6dB
(default: 0 dB)
Adjust the input level separately for each of the external inputs from
–6dB to +6dB in steps of 3dB.
Audio Out Settings
Digital Out On • Activates the digital audio output.
Off Deactivates the digital audio output.
When set to Off , all the following Audio Out settings are grayed out.
Dolby Digital Out Dolby Digital • Output a Dolby Digital signal when a Dolby Digital source is being
played.
Dolby Digital PCM Convert Dolby Digital sources to Linear PCM output. Use if your con-
nected equipment doesn’t have a Dolby Digital decoder.
DTS Out On • Output a DTS signal when a DTS source is being played.
Off Switch off the digital output when a DTS source is being played. Use
when your connected equipment doesn’t have a DTS decoder. In this
case, use the analog audio outputs.
96 kHz PCM Out 96 kHz 48 kHz • Convert 96 kHz digital audio sources to 48 kHz output. Use if your con-
nected equipment doesn’t support 96 kHz sampling rate.
96 kHz Output 96 kHz digital audio when a 96 kHz source is being played.
MPEG Out MPEG Output an MPEG audio signal when a source using MPEG audio is
being played.
MPEG PCM • Convert sources with MPEG audio to Linear PCM output. Use if your
connected equipment doesn’t have an MPEG audio decoder.
Setting Options Explanation
DVR-530H_KU.book 93 ページ ２００５年６月８日 水曜日 午前１１時１６分