Polycom KIRK 7010 - Manual (Page 7)

Polycom KIRK 7010-7020-7040 User Guide Battery Information
8 Polycom, Inc.
The part numbers for the 70- Handset Series charger and Power Supply Unit
are the following:
• Charger part number: 8464 2489
• Power Supply Unit part number: 8464 2601
Battery Information
The battery is connected to the handset from factory and must not be removed.
To replace the battery, please contact your local distributor.
The only battery that can be used for the 70 - Handset Series is the following:
• Battery part number: 8474 3424.
Charging Battery
When charging battery for the first time, it is necessary to leave handset in
charger for 14-16 hours for the battery to be fully charged.
During normal operation, it takes approximately 6 hours to charge the handset
from fully discharged to its full capacity.
Turning the backlight off reduces
charging time with approximately 2 hours (refer to “Turning Backlight Off” on
page 54 ).
Place handset in charger.
For correct charging, be sure the room temperature is between 0°C and 40°C.
Do not place the handset in direct sunlight. The battery has a built-in heat
sensor which will stop charging if the battery temperature is too high.
If the handset is turned off when placed in charger, nothing indicates the
charging. There will be no reaction on incoming calls.
Note
The charger can only be used with this specific Power Supply Unit.