Primera Technology Disc Autoloader ADL-MAX - Manual

P/N 510976 - 091906
Installing the Disc Publisher
• Open the cover of the Disc Publisher.
• Lower the Disc Publisher onto the stand.
The pegs will correspond with the holes on
the bottom of the unit. There are several
sets of holes on the bottom of the Disc
Publisher. The pegs fit in the front-most
and outer most set of holes.
• Install the cables, ink cartridges etc.
according to the instructions in the Disc
Publisher users manual. The software for
the Disc Publisher should have been
installed before starting the ADL-MAX
setup.
5
Quick S
tart
© 2006 All rights reserved
• Load up to 100 discs in each of the bins.
Place them on the mounting pegs of the
unit.
Note: Be sure the far left side bin on the Autoloader and
Disc Publisher are left empty.
• Load up to 50 discs into the right bin of the
Disc Publisher Pro and up to 25 discs in a
Disc Publisher.
Loading Media 6
7
Calibrating the Autoloader to
the Disc Publisher
• Calibrate the arm to the Disc Publisher by
opening the PrimoDVD software or the
RoboPrint Software. The software will
detect the ADL-MAX and prompt you
to calibrate. Follow the on screen
instructions to calibrate the unit.
You can recalibrate at any time by opening
Primo DVD - Click the robotics menu - select
options - Click the Calibrate ADL-MAX
button. If you are using RoboPrint, click
Robot Options - Calibrate ADL-MAX.
•
After calibrating the Disc Publisher
position by moving the stand forward
or backward, make sure you tighten the
mounting bolts to the stand.
Note: The first time you launch the PrimoDVD or
RoboPrint software you may be directed to a
web page to download and install a firmware
update for your Disc Publisher or AutoPrinter.
Follow the instructions on the web page to
complete this update.
DISC AUTOLOADER