Battery, Maintenance – Poulan Pro 461ZX_966681801 LAWN TRACTOR User Manual

Page 36

Advertising
background image

MAINTENANCE

36

Battery

Your mower is equipped with a maintenance free

battery and does not need servicing. However,

periodic charging of the battery with an automotive

type battery charger will extend its life.
• Keep battery and terminals clean.
• Keep battery bolts tight.
• See chart for charging times.

IMPORTANT INFORMATION

Do not attempt to open or remove caps or
covers. Adding or checking level of electrolyte
is not necessary.

Always use two wrenches for the terminal
screws.

WARNING!

Do not short battery terminals by
allowing a wrench or any other object
to contact both terminals at the same
time. Before connecting battery,
remove metal bracelets, wristwatch
bands, rings, etc.

Positive terminal must be connected
first to prevent sparks from accidental
grounding.

8050-109

Remove battery hold-down to replace battery

Cleaning battery and terminals
Corrosion and dirt on the battery and terminals can
cause the battery to “leak” power.
1. Lift seat and rotate forward.
2. Disconnect BLACK battery cable first, then the

RED battery cable and remove the battery from
the machine.

3. Rinse the battery with plain water and dry.
4. Clean terminals and battery cable ends with wire

brush until shiny.

5. Coat terminals with grease or petroleum jelly
6. Reinstall battery.
Replacing battery
1. Lift seat and rotate forward.
2. Using two ½" wrenches disconnect BLACK

battery cable then RED battery cable.

3. Position deck to lowest setting.
4. From underside of frame, remove the nuts that

secure the battery hold-down.

5. Carefully remove the battery from the mower.
6. Install new battery with terminals in the same

position as the old battery.

7. Reinstall battery hold-down and secure with nuts

removed in Step 5.

8. First connect RED battery cable to positive (+)

battery terminal with hex bolt and hex nut.

9. Connect BLACK grounding cable to negative (-)

battery terminal with remaining bolt and nut

10. Tighten securely.
11. Lower seat

CAUTION!

Always wear eye protection when
around batteries.

STANDARD

BATTERY

STATE

OF

CHARGE

APPROXIMATE BATTERY CHARGING TIME*

TO FULL CHARGE AT 80

O

F / 27

O

C

Maximum Rate at:

50 Amps

30 Amps

20 Amps

10 Amps

12.6V

100%

- FULL CHARGE -

12.4V

75%

20 min.

35 min.

48 min.

90 min.

12.2V

50%

45 min.

75 min.

95 min.

180 min.

12.0V

25%

65 min.

115 min.

145 min.

280 min.

11.8V

0%

85 min.

150 min.

195 min.

370 min.

*Charging time depends on battery capacity,

condition, age, temperature and efficiency of charger

Advertising
This manual is related to the following products: