Auto-equalizing) 81, Auto ta and eq (auto-time alignment and auto, Equalizing) – Pioneer AVH-P6600DVD User Manual

Page 81: Using the auto-equalizer, Digitalsignalprocessor

Advertising
background image

WIDE (wide)NARROW (narrow)

# You can adjust parameters for each band of
the other speakers in the same way.

Note

You can select a center frequency for each band.
You can change the center frequency in 1/3-oc-
tave steps, but you cannot select frequencies that
have intervals shorter than 1 octave among the
center frequencies of the three bands.

Using the auto-equalizer

The auto-equalizer is the equalizer curve cre-

ated by auto TA and EQ (refer to Auto TA and

EQ (auto-time alignment and auto-equalizing)

on this page).

You can turn the auto-equalizer on or off.

1 Touch A.MENU and DSP and then touch

NEXT twice.

2 Touch AUTO EQ.

# You cannot use this function if auto TA and
EQ has not been carried out.

3 Touch a to turn the auto-equalizer on.

# To turn auto-equalizer off, touch b.

Auto TA and EQ (auto-time

alignment and auto-

equalizing)

Only when the multi-channel processor (e.g.,

DEQ-P8000) is connected to this unit, you can

operate this function.

The auto-time alignment is automatically ad-

justed for the distance between each speaker

and the listening position.

The auto-equalizer automatically measures

the car interior acoustic characteristics, and

then creates the auto-equalizer curve based

on that information.

WARNING

To prevent accidents, never carry out auto TA and
EQ while driving. When this function measures
the car interior acoustic characteristics to create
an auto-equalizer curve, a loud measurement
tone (noise) may be outputted from the speakers.

CAUTION

! Carrying out auto TA and EQ under the follow-

ing conditions may damage the speakers. Be
sure to check the conditions thoroughly be-
fore carrying out auto TA and EQ.
 When speakers are incorrectly connected.

(e.g., When a rear speaker is connected to
a subwoofer output.)

 When a speaker is connected to a power

amp delivering output higher than the
speakers maximum input power capabil-
ity.

! If the microphone is placed in an unsuitable

position the measurement tone may become
loud and measurement may take a long time,
resulting in a drain on battery power. Be sure
to place the microphone in the specified loca-
tion.

DigitalSignalProcessor

En

81

Section

15

DigitalSignalProcessor

Advertising