12 – controls and their functions – Panasonic AJ-D610WBp User Manual

Page 12

Advertising
background image

– 12 –

Controls and Their Functions

Audio Function Section (1)

r

AUDIO LEVEL CH1 (audio channel 1 recording level) control
When the AUDIO SELECT CH1/CH2 switch

u

is set to MAN, the recording level of audio

channel 1 can be adjusted by this control in addition to the AUDIO LEVEL CH1 control

t

on

the side panel.

s

MIC IN (microphone input) jack (XLR, 3-pin)
Connect an optional microphone to this jack. The power for the microphone is supplied from
this jack.

t

AUDIO LEVEL CH1/CH2 (audio channel 1/2 recording level) controls
When the AUDIO SELECT CH1/CH2 switch

u

is set to MAN, the audio level of audio channels

1 and 2 can be adjusted using these controls.
However, the audio CH1 level can also be adjusted using the AUDIO LEVEL CH1 control

r

on

the front panel.

u

AUDIO SELECT CH1/CH2 switch (audio channel 1/2 auto/manual level adjustment selec-
tor) switch
This selects the method used to adjust the audio levels of audio channels 1 and 2.
AUTO: For adjusting the levels automatically.
MAN:

For adjusting the levels manually.

v

AUDIO IN (audio input selector) switch
This selects the input signals to be recorded on audio channels 1 and 2.
FRONT [MIC]: The microphone input signals connected to the MIC IN jack

s

are recorded.

REAR [MIC]:

The microphone input signals connected to the AUDIO IN CH1/CH2 connec-
tors

y

are recorded.

REAR [LINE]:

The line input signals connected to the AUDIO IN CH1/CH2 connectors

y

are recorded.

w

REAR MIC POWER switch
ON:

The phantom power is supplied to the rear microphone.

OFF:

The phantom power is not supplied to the rear microphone.

x

CUE switch
CH1:

The audio CH1 signals are recorded on the cue track.

1/2:

The signals of audio CH1 and CH2 are mixed together and recorded on the cue track.

CH2:

The audio CH2 signals are recorded on the cue track.

y

AUDIO IN CH1/CH2 (audio input channel 1/2) connectors (XLR, 3P)
An audio component or microphone is connected here.

z

AUDIO OUT connector (XLR, 3P)
This is connected to an audio component. The audio channels are coupled to the MONITOR
SELECT switch



and switched in tandem.

{

DC OUT (DC power output) connector
This is the DC 12 V output connector. A current of approximately 100 mA can be taken out.

s

r

The accessory
control knob can be
attached to the
AUDIO LEVEL CH1
control.

Knob
(included)

Screw
(included)

Advertising