Panasonic WV-CL920 - Manual (Page 32)

-33-
• To reset COARSE and FINE to the values pre-
set at the factory, press and simulta-
neously. COARSE and FINE adjustments are
preset at the factory to zero-crossing of the AC
line phase.
• If the AC line contains noise (spike noise, etc.),
the stability of the vertical phase of the camera
video output signal may be disturbed.
7. White Balance Setting (WHITE BAL)
7-1. Auto-Tracing White Balance Mode (ATW)
You can select one of four modes for white balance
adjustment as follows:
• ATW1 (Auto Tracing White Balance 1)
In this mode, the color temperature is monitored
continuously and thereby white balance is set auto-
matically. The color temperature range for the prop-
er white balance is approximately 2 600 - 6 000K.
Proper white balance may not be obtained under
the following conditions:
1. The color temperature is out of the 2 600 -
6 000K range.
2. When the scene contains mostly high color
temperature objects, such as a blue sky or
sunset.
3. When the scene is dim.
In these cases, select the AWC mode.
Move the cursor to the WHITE BAL parameter and
select ATW1. The white balance of the camera is
automatically set.
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER OFF
AGC ON (DNR-H)
SENS UP OFF
SYNC INT
WHITE BAL ATW1
MOTION DET OFF
LENS DRIVE DC
END SET UP ENABLE
↵
↵
↵
• ATW2 (Auto Tracing White Balance 2)
Auto-tracing white balance of the sodium light
mode (ATW2)
In case that you select ATW2 for sodium light,
white balance is set automatically (Operation is not
needed).
Note: ATW1 and ATW2 do not appear for the
WHITE BAL parameter on the system con-
troller setup menu.