Answering device, Setup, Setting up the voice and fax message reception – Panasonic KX-FPC95 User Manual

Page 68

Advertising
background image

68

Setup

Setting up the voice and fax message reception

When the TAD/FAX mode is set, the unit will work as a fax machine and/or answering device.
If a fax call is detected, the unit will automatically receive the fax. If a voice call is detected, the
answering device will play a greeting message and the caller can leave a voice message.

You can use either the pre-recorded greeting messages (p. 69) or your own greeting message
(p. 70).

Note:

If the arrow (

) is already shown on the right

of the display and you wish to change the
ring count, turn the arrow off once then on
again by pressing

and

follow the instructions in step 3.

The incoming message recording time can
be changed (feature #10 on page 83).

For voice memory capacity for incoming
messages, see page 109.

When the remaining time is low, erase
unnecessary messages (p. 73).

While an incoming call is being recorded,
you can monitor it through the speaker. If this
feature is not required, set to “OFF” (feature
#67 on page 87).

AUTO ANSWER

AUTO ANSWER

JOG DIAL

SET

Display

1

Set feature #77 to “TAD/FAX” (p. 88).

2

If the arrow (

) is not shown on the right of

the display, turn it on by pressing

.

The unit will play the greeting message.

The display will show the number of rings
before the unit answers a call in the
TAD/FAX mode.

Display:

3

If necessary, rotate

until the

desired ring count (see below) is displayed,
and press

.

The remaining time for recording incoming
messages will be displayed.

Example:

ON

1

TIME

1

=

1

10m13s

SET

JOG DIAL

AFTER

1

2

1

RINGS

PICKUP

1

&RCV

1

CALL

AUTO ANSWER

Ring count in the TAD/FAX mode

You can choose from 1, 2, 3, 4, TOLL SAVER and RINGER OFF.

TOLL SAVER:

When you call the unit from a remote location, the number of rings will tell you if there are
any new voice messages. If the unit answers on the second ring, there is at least one
new recorded message. If the unit answers on the fourth ring, there are no new recorded
messages. To save the toll charges for the call, hang up immediately when you hear the
third ring. The third ring indicates that there are no new recorded messages.

RINGER OFF:

The unit will answer without ringing.

If you subscribe to a Caller ID service, set to 2 or more rings.

You can also select the setting with programming feature #06 (p. 83).

TAD/FAX mode

!

(using the built-in answering device and receiving
voice and fax calls automatically)

Advertising
This manual is related to the following products: