Pioneer S-DV440 - Manual (Page 55)

Other connections 11
55
En
English
Français
Deutsch
Nederlands
Italiano
Español
Important
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the system to progressive, you will not be
able to see any picture at all. In this case,
press
STANDBY/ON to put the system
in standby, then press and hold the front
panel
(stop) button for about 8 seconds
until the display shows Mem.Clr.? . Press
the front panel VOLUME – ( DOWN ) or +
( UP ) button so that the display shows
Interlace? . Press the front panel
button to set to interlace and switch the
system back on.
Compatibility of this player with
progressive-scan and high-definition TVs.
This player is compatible with progressive
video Macro Vision System Copy Guard.
Consumers should note that not all high-
definition television sets are fully compatible
with this product and may cause artifacts to be
displayed in the picture. In case of 525
progressive scan picture problems, it is
recommended that the user switch the
connection to the ‘standard definition’ output
(Interlace). If there are questions regarding our
TV set compatibility with this model, please
contact our customer service center.
This system is compatible with the following
Pioneer displays and monitors:
Plasma display
PDP-505HD, PDP-5030HD, PDP-4330HD, PDP-
5040HD, PDP-4340HD, PRO-10000HD, PRO-
800HD, PRO-1000HDI, PRO-800HDI, PRO-
1110HD, PRO-910HD, PDP-4300, PDP-5031
Projection monitor receiver
SD-533HD5, SD-643HD5, PRO-710HD, PRO-
610HD, PRO-510HD, PRO-720HD, PRO-
620HD, PRO-520HD, PRO-730HD, PRO-
630HD, PRO-530HD, PRO-730HDI, PRO-
530HDI
Using this unit with a Pioneer
plasma display
If you have a Pioneer plasma display (models
PRO-1110HD, PRO-910HD, PDP-5040HD and
PDP-4340HD), you can use an SR+ cable (see
note below) to connect it to this unit and take
advantage of various convenient features,
such as automatic video input switching of the
plasma display when the input is changed.
• Use a 3-ringed miniplug SR+ cable to
connect the CONTROL IN jack of this unit
through a media receiver to the CONTROL
OUT jack of your plasma display.
Before you can use the extra SR+ features, you
need to make a few settings in the unit. See
SR+ control options for Pioneer plasma displays
on page 44 for detailed instructions.
AM
LOOP ANTENNA
FM
UNBAL 75 Ω
IN
ANTENNA
CONTROL
COMPONENT VIDEO OUT
P R P B Y
OUT
CONTROL
Pioneer plasma display
XV-DV440/740
Media receiver
XV-DV323.book 55 ページ ２００４年２月１０日 火曜日 午後６時１０分