Initial settings adjusting initial settings 24, Adjusting initial settings, Setting the fm tuning step – Pioneer DEH-4700MP User Manual

Page 24: Switching auto pi seek, Saving the battery consumption, Initial settings

Advertising
background image

Adjusting initial settings

1

Initial settings lets you perform initial setup of

different settings for this unit.

1 Function display

Shows the function status.

1 Press SOURCE and hold until the unit

turns off.

2 Press SOURCE and hold until FM ap-

pears in the display.

3Press AUDIO to display the function

names.

Press AUDIO repeatedly to switch between

the following settings:

FM (FM tuning step)A-PI (Auto PI Seek)

SAVE (Power save)

Use the following instructions to operate each

particular setting.

# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down SOURCE until the unit turns off.

Setting the FM tuning step

Normally the FM tuning step employed by

seek tuning is 50 kHz. When AF or TA is on,

the tuning step automatically changes to 100

kHz. It may be preferable to set the tuning step

to 50 kHz when AF is on.

! The tuning step remains at 50 kHz during

manual tuning.

1 Press AUDIO to select FM.

2 Press c or d to select the FM tuning

step.

Press c to select 50 (50 kHz). Press d to se-

lect 100 (100 kHz).

Switching Auto PI Seek

The unit can automatically search for a differ-

ent station with the same programming, even

during preset recall.

1 Press AUDIO to select A-PI.

2 Press a or b to turn the Auto PI seek

on or off.

Saving the battery

consumption

It is possible to save the battery consumption

when this unit is turned off. After one minute

of turning off this unit, this unit will be

switched into power save mode.

! You cannot insert and eject a disc while

this unit is in power save mode.

! You can only use SOURCE while this unit is

in power save mode.

Important

When you disconnect a battery in order to replace
it, this mode is turned off. When installing this
unit in a vehicle that does not have an ACC (ac-
cessory) position on the ignition switch, the vehi-
cle battery may be drained depending on a
connection method. After checking the connec-
tion method, turn this mode on if needed.

1 Press AUDIO to select SAVE.

2 Press a or b to turn power save on or

off.

Initial Settings

En

24

Section

09

Advertising
This manual is related to the following products: