Panasonic SCHT56 - Manual (Page 13)

13
RQTX0175
Settings
2a Select and press [ENTER].
Refer to pages 13 and 14 for each item settings.
For “REMOTE”, refer to page 21.
For “RESET”, refer to page 19. •
•
•
2b Select and press [ENTER].
Press repeatedly
until “EXIT” appears.
Press and hold.
DISTANCE ↔ AUTO SETUP ↔ INPUT
MODE ↔ HDMI ↔ DRCOMP ↔
ATTENUATOR ↔ REMOTE ↔ TV DELAY ↔
RESET ↔ EXIT
Enter the
setup mode. 1 Select the item you want to change. 2 Change the
setting. 3 Exit the
setup mode. 4
Press [ENTER] to
completely exit the
setup mode.
Press to change the
setting.
Press once to enter.
Auto speaker setup calibration will give optimal result for “DISTANCE”. Therefore, you are unable to adjust the setting manually.
Note
Change the settings to suit your equipment
to the environment in which you are using
it. Before making any changes, read the
descriptions of the settings, note the factory
settings and ranges, and refer to the
equipment's instructions.
Settings
Change the distance so that the sound from all the speakers (except for the
subwoofer) reaches you at the same time.
You can select distances between 3 feet and 30 feet.
The factory settings are: 10 ft (feet)
10 ft (feet)
5 ft (feet)
LR (front):
C (center):
S (surround):
Enter the distance of the front, center and surround speakers from
the seating position. • Distance
YES: Reset all auto speaker setup settings
NO: To cancel (factory setting)
Auto setup Reset the settings done in auto speaker setup. •
(continue on next page)
DISTANCE LR
3 feet to
30 feet
C
S
AUTO SETUP DEFAULT NO
YES
INPUT MODE TV
AUTO
ANALOG
DIG
PCMFIX
DVR
DVD
3 2a 2b
Repeat for each speaker channel
1 In rare cases, the unit may have trouble recognizing PCM signals and this may cause the beginning of tracks to be cut off.
Select “PCMFIX” if this occurs.
With DTS, the signals may not be recognized at all. Engage the DTS FIX mode if this occurs.
To engage the DTS FIX mode:
Press and hold [-MENU] and [ENTER] at the same time. “DTS” lights.
To cancel the DTS FIX mode:
Press and hold [-MENU] and [ENTER] at the same time.
The mode cancels when input mode is set to AUTO or when the unit is turned off.
When a FIX mode is on, the unit cannot process other signals. This may cause noise to be output. If this occurs, select an
input mode other than PCMFIX, or cancel the DTS FIX mode.
•
Note
AUTO: The unit automatically detects whether input is digital or analog.
(factory setting)
ANALOG: Select to make the unit accept analog input.
DIG: Select to make the unit accept digital input.
PCMFIX
1 : Select to input to PCM.
This unit automatically detects whether input is digital or
analog, but you can fix the input mode. • Input mode
Display
Switch on.
SC-HT56P_MP (RQTX0175-2P).indb 13 9/19/2008 12:28:32 PM