Panasonic PT-DZ6710 - Manual (Page 26)

Settings
DISPLAY OPTION menu
E
NGLISH - 26
You can change the AUTO SETUP feature for specific signals.
Press I H to cycle through the options and press the ENTER
button to perform the AUTO SETUP.
J DVI EDID
You can switch the EDID setting and signal level for
variable DVI signals.
J DVI SIGNAL LEVEL
(PT-DZ6710 only)
You can select signal amplitude type.
J OSD POSITION
You can change the displaying position of the main
menu. Press I H to cycle through the options.
J OSD DESIGN
You can change the background colour of the menu.
Press I H to select the required option.
J OSD MEMORY
The current menu cursor position will be retained
temporarily unless the projector switched off.
J INPUT GUIDE
The name of current selected input terminal will be
displayed where the position that is selected in OSD
POSITION.
J WARNING MESSAGE
You can prevent the display of waning messages.
AUTO SETUP
DEFAULT
For 4:3 or 5:4 signals
Applicable resolution: 640 x 400, 640 x480,
800 x 600, 832 x 624, 960 x 720, 1 024 x 768,
1 152 x 864, 1 152 x 870, 1 280 x 960,
1 280 x 1 024, 1 600 x 1 200, 1 400 x 1 050
WIDE
For wide signals
Applicable resolution: 720 x 400, 848 x 480,
1 280 x 720, 1 024 x 600, 1 120 x 750,
1 440 x 900, 1 680 x 1 050
USER
For specific resolution signals
Select the required MODE and change the
DISPLAY DOTS value by pressing I H.
DVI-D IN
NOTE:
• The DVI-D IN setting for the best quality depends on the
output equipment. Refer the instructions of the connected
equipment.
• DVI signal is very sensitive, and malfunction may occur or
other problems could be encountered with some DVI
equipment.
EDID3
Switch between fine settings for a
moving image and for a still image.
EDID1
Fine setting for mainly a moving
image, such as signals from a DVD
player.
EDID2(PC)
Fine setting for mainly a still image,
such as computer.
0-255:PC
(PC scale) For connecting to a
computer via DVI-D IN terminal
16-235
(TV scale) For connecting to AV
equipment via DVI-D IN terminal, such
as a DVI - HDMI conversion cable
connection
SDI IN
64-940 Normal setting
4-1019
For when grey colour is too close to
black
NOTE:
• Available with YP B P R or RGB of HD-SDI signal.
• Usually 64-940 setting is recommended.
ON-SCREEN DISPLAY
1
Upper left
4
Upper centre
7
Upper right
2
Left
5
Centre
8
Right
3
Lower left
6
Lower centre
9
Lower right
1 Yellow 4 Green
2 Blue 5 Pink
3 White 6 Brown
ON Memorise the menu cursor position.
OFF Reset the cursor position.
ON
Displays the current selected input
terminal.
OFF Deactive
ON
All of the warning messages will be
displayed.
OFF
None of the warning messages will be
displayed.
NOTE:
• When the WARNING MESSAGE is set to OFF, use the
projector with utmost care due to none of the warning
messages will be displayed.