Panasonic AJ-D750P - Manual (Page 13)

<Front Panel Center Section>
Volume control
This is used to adjust the headphones volume and the monitor output volume.
Whether the headphones output and monitor output volumes are to be linked or kept
separate can be set on-screen menu. (Note that the headphones output volume is
normally linked.)
When the volumes are kept separate, the monitor output is set to the unity value (preset
value).
MONITOR SELECT switches
These are used to select the audio signals output to the monitor L/R channels.
Each time the “L” button is pressed, the signals output to the monitor L channel are
selected in turn in the following order: CH1, CH2, CUE and back to CH1.
Each time the “R” button is pressed, the signals output to the monitor R channel are
selected in turn in the following order: CH1, CH2, CUE and back to CH1.
The L or R lamp on the level meter display lights to indicate which signal is now being
selected. (When MONI CH SEL is set to AUTO at the on-screen menu No. 713, the
display may not match the monitor output.)
MONITOR SET button
This is used when outputting the MIX signal to the monitor L/R channels.
When the MONITOR SET and L or R buttons are pressed together, the CH1 and CH2
MIX signal can be output to the monitor L or R. When these buttons are pressed together
again, MIX is released.
- 1 3 -