Panasonic GCSEB E - Manual (Page 4)

4
RQT7429
Fr
ont
a
nd su
rr
o
und spe
a
k
e
r as
semb
ly
Simple setup
Front and surround speaker assembly
[Note]
The front and surround speaker pairs as well as the pipe pairs are
different.
– Check the label on the rear of the speaker before attaching the
pipe (‹ page 8).
– The pipe with the shorter cable is for the front speaker unit.
Preparation
≥To prevent damage or scratches, lay a soft cloth and perform
assembly on it.
≥For assembly, use a Phillips-head screwdriver.
1
Attach the pipe to the base.
1 Thread the speaker cable through the base.
2 Insert the pipe.
3 Secure the pipe to the
base.
Ensure the screw is
securely fastened.
2
Attach the stand to the front and
surround speaker.
≥There is no difference between the right and left speakers and stands.
≥Using the polyfoam included with this unit may be convenient.
1 Remove the screw and separate the mounting plate into
two parts.
2 Attach the plate A to the speaker.
Ensure the plate A is fastened on straight by lightly tightening the
top and bottom screws alternately until fully tightened.
You can also attach to the upper rear of the speaker.
The height of the speaker is indicated in the diagram
(‹ page 5) when attaching the plate A to the upper rear or
lower rear of the speaker.
3 Place the pipe on the plate A and attach the plate B.
4 Secure the plate with the same screw removed in
procedure 1.
Make sure you have all the indicated components before starting the assembly, setup, and
connection.
4 pipes
4 large washer
screws 2 front and
2 surround
speaker units
8 small screws
4 bases
4 mounting plates
STEP
1
[HT870]
The supplied stands are specially designed for attachment
to Panasonic SB-PF921 front speakers and SB-PS921
surround speakers. Only use as indicated in this setup.
Lessen excess speaker cable.
Thread the
speaker cable
through here.
Cable
Hole for screw
Groove
Insert the pipe while slightly
pulling on the speaker cable.
Rear side of base
Large
washer
screw
Cable
Plate A Plate B
Small screw
Small screws
Speaker
Plate A
Polyfoam
Rotate the pipe so that the flat
side is facing away from the
back of the speaker. Plate B
Fit the offset into the slot
and slide the plate B into
the locked position.
Offset
Slot
Plate B
Small screw
7429en-p03-30.fm 4 ページ ２００４年３月５日 金曜日 午後１１時２７分