Display panel instructions – Panasonic KV-S2065L User Manual

Page 18

Advertising
background image

18

Display Panel Instructions

Others menu

No.

Item

LCD display

Contents

Page

01

Checking the version

Version

Displays the firmware version of the mechanical
control, pre-imprinter or post-imprinter. If an optional
imprinter is not installed, the imprinter version will not
be displayed.

27

02

Setting the buzzer

Buzzer

Selects whether the buzzer is turned on or off. If
selection is in the “ON” position:
When pressing a key, one short beep will be heard.
When there is an error, 5 short beeps will be heard.
When scanning is completed correctly, one long beep
will be heard.

03

Setting the SCSI ID

SCSI ID

Sets the SCSI ID number.

04

Setting the terminator

Terminator

Sets “Enable” or “Disable”.
“Enable” : If last device on chain.
“Disable” : If between devices.

05

Setting the transfer
rate

Transfer Rate

Changes the maximum value of the synchronous
transfer rate of the SCSI interface.

Lower the synchronous transfer rate to 10 Mbytes/
sec. if the computer has failed to recognize the
scanner or the scanner fails to operate properly.

06

Checking the roller
cleaning warning

Clean Roller

The alarm tells you it is time to check the roller. If it is
near 100%, clean the roller. See “Cleaning the Unit” on

page 36

.

28

Clearing the roller
cleaning warning

Clean Roller

Clear the “Clean Roller Warning

≤≤

%” display.

07

Checking the roller
modules replacement
warning

Replace Roll.

The alarm tells you the roller needs to be changed. If it
is near 100%, replace the paper feed roller module and
retard roller module. See “Replacing Consumables” on

page 41

.

Clearing the roller
modules replacement
warning

Replace Roll.

Clear the “Replace Roll. Warning

≤≤

%” display.

08

Setting the product
ID

Product ID

Selects the product ID. The product ID setting depends
on the host computer scanner application you are
using. Allows scanner to emulate other Panasonic
scanners.

09

Setting the sleep
mode

Sleep Mode

Sets the time until sleep mode turns ON.

Advertising
This manual is related to the following products: