Remote control, Additional information 12, Resetting the main unit – Pioneer VSX-1015-K User Manual

Page 73: Switching the speaker impedance, Changing the tv format setting

Advertising
background image

Additional information

12

73

En

Remote control

Note

• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug

from the outlet and insert again to return to normal operating conditions.

Resetting the main unit

Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.

1

Switch the receiver into standby.

2

While holding down the TONE button, press and

hold the

STANDBY/ON button for about three

seconds.

3

When you see RESET? appear in the display,

press ENTER.
OK?

shows in the display.

4

Press SYSTEM SETUP to confirm.

OK

appears in the display to indicate that the receiver

has been reset to the factory default settings.

Switching the speaker impedance

We recommend using speakers of 8

with this system,

but it is possible to switch the impedance setting if you
plan to use speakers with a 6

impedance rating.

With the receiver in standby, press

STANDBY/

ON while holding down the SPEAKERS button.

Each time you do this, you switch between the
impedance settings:

SP 6 OHM

– Use this setting if your speakers are

rated at 6

.

SP 8 OHM

– Use this setting if your speakers are

rated at 8

or more.

Changing the TV format setting

If the

System Setup

menu is not displayed correctly, it

may be that the TV system is set incorrectly for your
country or region.

With the receiver in standby, press

STANDBY/

ON while holding down the SIGNAL SELECT button.

The display shows the new setting (

PAL

or

NTSC

).

Symptom

Cause

Remedy

Cannot be remote controlled.

• The remote control batteries have worn out. • Replace the batteries (see

Loading the batteries

on

page 7).

• Too far away or improper angle of operation. • Operate within 7 meters and a 30º angle of the remote

sensor on the front panel (see

Operating range of remote

control unit

on page 30).

• There is an obstacle between the receiver
and the remote control.

• Remove the obstacle or move to another place.

• Strong light such as fluorescent light is
shining onto the unit's remote control sensor.

• Avoid exposing the remote sensor on the front panel to
direct light.

• Something is plugged into the

CONTROL IN

jack.

• Unplug the cable from the

CONTROL IN

jack and use

remote normally (see

Operating other Pioneer components

on page 23).

Other components can't be
operated with the system
remote.

• The preset code settings are wrong.

• Input the correct preset code.

• The batteries wore out and the system
settings were cleared.

• Reset the proper system settings.

The SR cable is connected, but
the connected components can’t
be operated with the remote.

• The SR cable hasn't been connected
properly.

• Reinsert the SR cable, making sure it’s connected to the
right jack (see

Operating other Pioneer components

on

page 23).

• The rest of the component connections
have not been made.

• Make sure an analog connection has been made
between the units.

• The component you have hooked up is not a
Pioneer product.

• This feature only works with Pioneer products.

VSX_1015.book.fm 73 ページ 2005年3月7日 月曜日 午後7時0分

Advertising
This manual is related to the following products: