Panasonic EY7410 - Manual (Page 7)

- 7 -
● Do not look at the light or shine it
directly into your eyes.
Continuous exposure to the LED
light may damage your eyes.
1. Press to toggle the light on
and off.
●
To use the light immediately after
attaching the battery pack or after
the drill has not been used for 5
minutes or more, operate the drill
briefly.
● The light will automatically turn
off if the drill is not used for 5
minutes.
● The light uses an extremely small
amount of current. Using the light
has a negligible effect on the
operational capacity of the drill.
● The LED is incapable of lighting
the tip of the bit when the drill is
used in the straight configuration.
 Bit-locking Function
With the switch at off and the bit lock-
ed in place, the tool can be used as a
manual screw-driver - up to 1.7 N·m
(150 kgf-cm, 10 in-lbs).
There will be a little play in the driving
shaft, but this is not a malfunction.
 Main Switch (ON/OFF)
Push the upper half of the switch for
forward rotation, or the lower half for
reverse rotation.
Forward
Forward
Reverse
Reverse
 Speed Selector Switch
To suit the application of this tool, two
different rotational speeds are avail-
able. Depending upon use, either the
high or low speed should be select-
ed.
HIGH LOW
Speed selection Torque
LOW 00 /min (rpm) High
HIGH 600 /min (rpm) Low
CAUTION:
• Check speed selector switch before
use.
• Do not operate the speed selector
switch while the main switch is on
(switch is in the ON position).
 Main Switch Lock
After use, set the main switch lock at
the lock position to prevent accidental
operation.
EY7410(EU).indb 7 2006/07/19 17:27:48