Phantom Tech CAM60 - Manual (Page 4)

4 – CAM150 / CAM60 CAM150 / CAM60 – 5
3. FRONT PANEL FEATURES
1. INPUT LEVEL
These controls allow you to individually adjust the volume
level of each of the four balanced inputs, and the Aux
input. We recommend that you turn down the level controls
of any unused or little-used inputs.
2. EQ-LO
Turn this clockwise to boost the level of the low-frequency
range below 100 Hz. Turn it counter-clockwise to cut the
level. In the center position, there is no change in level.
The maximum boost and cut is 10 dB at 100 Hz.
3. EQ-HI
Turn this clockwise to boost the level of the high-frequency
range above 10 kHz. Turn it counter-clockwise to cut the
level. In the center position, there is no change in level.
The maximum boost and cut is 10 dB at 10 kHz.
4. MASTER VOLUME
Use this volume control to adjust the sound output level
to your speakers. Adjust the master level and the input
levels to average settings, not too high and not too low.
For example, if you find you have to turn the master volume
up high, then the input level controls might be set too low.
If the master volume becomes loud after a small rotation,
then the input level controls might be set too high.
5. LED METER
This meter shows the signal level reaching the input
section of the main power amplifier.
The lower eight LEDs represent the area between -20 dB
and 0 dB. Adjust the Master Volume to keep your output
within these levels.
Make sure the top two LEDs are not lit, or the outgoing
signal will clip and distort. Turn down the Master Volume
level so the top two LEDs do not light.
� � � � � � �
�������� ��������������������� ��������������������
������������������ �������������������� �����������������������
������� ������� ������� �������
�������
���
���
���
���
���
�����
��
�
�
��������
� � ��� ������
� � � � �������� ��
�� ���� ���� ���� � ���� �����������
��
���
�����
���
�������������������������
��
�������
���
���� ���
�������
���
���� ���
�������
���
���� ���
�������
���
���� ��� ���������� ������������ ������������� �������������
© 2004 LOUD TECHNOLOGIES INC.
"EAW" IS A REGISTERED TRADEMARK
OF LOUD TECHNOLOGIES INC.
CAM150-MIXER AMPLIFIER
6. POWER SWITCH
Use this switch to turn the unit on or off. The power is on
when the top of the switch is pressed, and off when the
bottom is pressed. Turn it off if you are not using the unit
for long periods of time.
1 2 3 4
5
6