Pioneer DVD Navigation Unit AVIC-80DVD - Manual (Page 171)

169
Appendix
When the screen is frozen...
Park your car at a safe place, and cut the engine off. Turn the ignition key back to “Acc off”.
Then start the engine again, and turn the power to the main unit back on. If this does not solve
the problem, press the reset button on the main unit.
If the display suddenly disappears (in case of AVIC-9DVD, AVIC-90DVD)
When using the Navigation System with another manufacturer’s display, if the display suddenly
disappears, setting of the image output may have changed.
Set again by following the instructions below.
1. Park your car in a safe place, and pull the side brake.
2. Turn the power of the main unit off (cut off the engine).
3. While pressing [ ] (AUDIO) button on the bottom left of the numeric keypad of the Remote
Controller, turn the ACC on (start the engine).
Image output is switched, as the image of the navigation (RGB image) is output from RCA
Video output, and the image is displayed on the screen.
•