Pioneer DVR-LX60D - Manual (Page 20)

Connections 02
20
En
2 Use a SCART cable (not supplied) to
connect the AV1 (RGB)-TV AV connector
to a SCART AV connector on your TV.
This enables you to watch discs.
3 Use another SCART cable to connect
the AV2 (INPUT 1/DECODER) AV
connector to a SCART AV connector on
your decoder box.
This enables you to record scrambled TV
channels.
Connecting to an AV
amplifier/receiver
To enjoy multichannel surround sound you
need to connect this recorder to an AV
amplifier/receiver using the digital coaxial
output.
In addition to a digital connection, we
recommend also connecting using the
stereo analog connection for compatibility
with all discs and sources.
You’ll probably also want to connect a video
output to your AV amplifier/receiver. Use the
ordinary video output (as shown here), or the
S-video output.
Important
• Noise may be output from your speakers
if the recorder is not set up to work with
your AV amplifier/receiver properly (see
Audio Out on page 133).
• When watching D.TV only linear PCM
audio is output from the coaxial digital
out jack.
• Do not connect this recorder to your TV
‘through’ your VCR using A/V cables.
Always connect it directly to your TV.
1 Connect your TV antenna to the
recorder and TV.
See Connecting a TV antenna on page 15 for
details.
This enables you to watch and record TV
channels.
2 Connect the DIGITAL AUDIO OUT
(COAXIAL) jack on this recorder to a
coaxial digital input on your AV
amplifier/receiver.
This enables you to listen to multichannel
surround sound.
3 Connect the analog AUDIO OUTPUT
and VIDEO OUTPUT jacks on this recorder
to an analog audio and video input on
your AV amplifier/receiver.
4
Connect the AV amplifier/receiver’s
video output to a video input on your TV.
Connecting using HDMI
If you have an HDMI or DVI-equipped
1
monitor or display 2 , you can connect it to
this recorder using an HDMI cable (not
supplied).
Note
1 Depending on the component you have connected, using a DVI connection may result in unreliable signal
transfers.
2 The pixel resolution of this recorder’s HDMI video output is (according to TV format): NTSC (720 x 480i/p, 1280
x 720p, 1920 x 1080i/p) and PAL (720 x 576i/p, 1280 x 720p, 1920 x 1080i/p). If your display is not compatible with
these resolutions the picture may not be correctly reproduced.
AC IN
DIGITAL AUDIO OUT
COAXIAL HDMI OUT
CONTROL
G-LINK IN
AV 1 (RGB) – TV
AV 2 (INPUT 1/DECODER)
S-VIDEO
VIDEO AUDIO L R
INPUT 3
COMPONENT VIDEO OUT Y P B P R
ANTENNA
IN
OUT
ANTENNA(DIGITAL) IN OUT
5 V 30 mA
OUTPUT
TV
AV amp/
receiver
3 2
4
AUDIO/VIDEO
OUTPUT
DIGITAL
AUDIO OUT
To audio/video input To digital input
To video input
From video
output
DVRLX60D_WV_EN.book 20 ページ ２００７年３月２６日 月曜日 午後１２時１６分