Pioneer DCS-370 - Manual (Page 44)

Additional information 10
44
En
Error Messages
Resetting the system
Use the front panel controls to reset all system
settings to the factory default.
• With the system on, press  STANDBY/
ON while holding down  USB.
The next time you switch on, all the system
settings should be reset.
Setting the Key Lock
You can disable the front panel buttons by
switching the Key Lock feature on.
1 With the system in standby, press SETUP
and use
/ to choose KEYLOCK then press
ENTER.
This is shown in the front panel display.
2 Use / to select LOCK ON or LOCK OFF
then press ENTER.
Using the language code list
Some of the language options (see Language
settings on page 28) allow you to set your
preferred language from any of the 136
languages in the Language code list below.
1 Select ‘Other Language’.
2 Use / to select either a code letter or
a code number.
3 Use / to select a code letter or a code
number.
See the Language code list below for a
complete list of languages and codes.
Color problems occur
with your monitor after
changing the
HDMI
Color setting (page 27).
• Depending on the connected equipment, some HDMI Color settings may cause
the picture to be displayed incorrectly. In this case, use the TV’s own video input
settings to select RGB, if possible. Alternatively, revert to the previous
HDMI Color
setting.
Problem Remedy
Message Description
LINE ON • An operation is prohibited because the Line Out mode is on (page 33).
EXTRAPWR • You cannot adjust SFC modes or tone controls (bass, treble, and bass boost)
when using Extra Power mode.
SND. DEMO • The sound demo is on. See General in Troubleshooting on page 41.
CANNOT • An operation is prohibited because DVD/CD or USB isn’t selected, headphones
are connected, or TEST TONE is pressed during disc playback.
MUTING • An operation is prohibited because the sound is muted (press MUTE).
STEREO • An operation is prohibited because the DVD/CD or USB function isn’t selected.
TRAYLOCK • The tray lock is on. See General in Troubleshooting on page 41.
KEYLOCK • The key lock is enabled. See Setting the Key Lock below.
USB ERR • See Important in Using the USB interface on page 23 for more on this.
HDMI ERR • See HDMI connection above for troubleshooting tips. See also Resetting the
HDMI connection on page 34 if the problem persists.
EEP ERR • Contact your Pioneer authorized service center or your dealer for servicing.
EXIT • Appears when a menu is automatically exited after a set period of inactivity.
DCS-363.book 44 ページ ２００７年４月１８日 水曜日 午後３時３８分