Planet Technology FGSW-2624SF - Manual (Page 9)

- 9 -
Per 10/100/1000Base-T port /SFP interfaces (FGSW-2620VSF only)
LED Color Function
LNK/ACT
1000
Green
Lit: indicate that the port is operating at 1000Mbps.
Off: indicate that the port is operating at 10Mbps or 100Mbps.
Blink: indicate that the switch is actively sending or receiving data over that port.
LNK/ACT
100
Green
Lit: indicate that the port is operating at 100Mbps.
Off: indicate that the port is operating at 10Mbps or 1000Mbps.
Blink: indicate that the switch is actively sending or receiving data over that port.
FDX Green
Lit: indicate that the port is operating at full-duplex mode.
Off: indicate that the port is operating at half-duplex mode.
Per 100Base-FX port (FGSW-2624SF only)
LED Color Function
LNK/ACT Green
Lit: indicate that the port is operating at 100Mbps.
Off: indicate that the port is link down
Blink: indicate that the switch is actively sending or receiving data over that port.
#
Notice:
1. Press the RESET button once. The Web Smart Switch will reboot automatically.
2. Press the RESET button for 5 seconds. The Web Smart Switch will back to the factory default
mode; the entire configuration will be erased.
3. The FGSW-2402VSv2 must work with MII-V series module for 100Base-FX fiber connection.
4. The 2 Gigabit TP/SFP combo ports are shared with port 25/26 of FGSW-2620VSF/
FGSW-2624SF.Either of them can operate at the same time.
2.2 Rear Panel
The rear panel of the Web Smart Switch indicates an AC inlet power socket, which accepts input power from 100 to
240VAC, 50-60Hz.
Figure 2-4: FGSW-2402VS/FGSW-2620VSF Switch rear panel
ON
OFF
POWER
Figure 2-5: FGSW-2624SF Switch rear panel
Power Notice:
1. The device is a power-required device, it means, it will not work till it is powered. If your networks should active all the
time, please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network data
loss or network downtime.