PYLE Audio IKON RUGGED 7505-BT - Manual (Page 317)

Appendix A: Summit Client Utility (SCU)
ThirdPartyConfig
Ikôn Rugged PDA (Windows Mobile 6.1) User Manual A-7
• If the credentials are not specified in the profile, when the radio tries to associate using
that profile, you will be prompted to enter the credentials.
• When prompted, you can enter valid credentials, enter invalid credentials, or cancel
the operation.
• If you enter valid credentials and tap OK, the radio will associate and authenticate.
• If you enter invalid credentials and tap OK, the radio will associate but will not authen-
ticate; you will be prompted again to enter credentials.
• If you tap Cancel or clear the credentials fields and tap OK, the radio will not attempt to
associate with that profile until you perform one of the following actions (while the
profile is the Active Profile):
- Cause the Ikôn to go through a power cycle or suspend/resume.
- Disable and enable the radio, or tap the Reconnect button on the Diags windows.
- Modify the profile, and tap on Commit.
Alternatively, you can choose another profile as the active profile and then switch back to
the profile for which EAP authentication was cancelled.
A.3.3 ThirdPartyConfig
If you choose to configure ThirdPartyConfig, the SCU will work with the operating sys-
tem’s Windows Zero Config (WZC) to configure radio and security settings for the CF radio
installed in the unit.
Choosing this profile means that WZC must be used to define the following radio and secu-
rity options: SSID, Auth Type, EAP Type and Encryption. The SCU settings for
ThirdPartyConfig include: Client Name, Power Save, Tx Power, Bit Rate and Radio Mode.
These SCU settings along with SCU global settings and the WZC settings will be applied to
the radio module.