Pioneer KEH-P7020R - Manual (Page 32)

Audio Adjustments
Fine adjusting equalizer curve
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (
EQ Low/EQ Mid/EQ High ).
1 Press AUDIO and hold unitil frequency and
the Q factor (e.g., F 80 Q 1W ) appears in the
display.
2 Press AUDIO to select the desired band for
adjustment.
LOW (low)— MID (mid)— HIGH (high)
3 Select the desired frequency with
2/3.
Press
2 or 3 until the desired frequency
appears in the display.
LOW : 40 — 80 — 100 — 160 (Hz)
MID : 200 — 500 — 1 k — 2 k (Hz)
HIGH : 3.15 k—8 k — 10 k — 12.5 k (Hz)
4 Press
5/∞ to select the desired Q factor.
Press
5 or ∞ until the desired Q factor appears
in the display.
2 N — 1 N — 1 W — 2 W
Note
• If you make adjustments when a curve other
than CUSTOM2 is selected, CUSTOM1 curve
is updated.
Adjusting bass
You can adjust the cut-off frequency and the
bass level.
• In
FRT1 mode, bass adjustment affects only
the rear output: front output cannot be
adjusted.
1 Press AUDIO to select Bass .
Press AUDIO until Bass appears in the display.
2 Select the desired frequency with
2/3.
Press
2 or 3 until the desired frequency
appears in the display.
40 — 63 — 100 — 160 (Hz)
3 Press
5 or ∞ to adjust the bass level.
Each press of
5 or ∞ increases or decreases
the bass level. +6 – –6 is displayed as the level is
increased or decreased.
Adjusting treble
You can adjust the cut-off frequency and the
Treble level.
• In
FRT1 and FRT2 modes, treble adjustment
affects only the front output: rear output cannot
be adjusted.
1 Press AUDIO to select Treble .
Press AUDIO until Treble appears in the display.
2 Select the desired frequency with
2/3.
Press
2 or 3 until the desired frequency
appears in the display.
2.5k — 4k — 6.3k — 10k (Hz)
3 Press
5 or ∞ to adjust the treble level.
Each press of
5 or ∞ increases or decreases
the treble level. +6 – –6 is displayed as the level is
increased or decreased.
En 32
07
Section
Level (dB)
Center frequency Frequency (Hz)
Q=2N
Q=2W