Pioneer KEH-P7020R - Manual (Page 38)

Initial Settings
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car’s headlights are turned on. You
can switch dimmer on or off.
1 Press FUNCTION to select DIM .
Press FUNCTION repeatedly until Dimmer
appears in the display.
2 Select DIM on or off with
5/∞.
Pressing
5/∞ will switch
Dimmer between on
and off and that status will be displayed (e.g.,
Dimmer :ON ).
Selecting the brightness
You can select the display brightness. Initially
this mode is set to 12.
1 Press FUNCTION to select BRIGHT .
Press FUNCTION repeatedly until Brightness
appears in the display.
2 Select the desired brightness with
2/3.
• The display shows 0 – 15 .
Selecting the illumination color
This product is equipped with two illumination
colors, green and red.
You can select the desired illumination color.
1 Press FUNCTION to select ILL .
Press FUNCTION repeatedly until ILLUMI
appears in the display.
2 Select the desired illumination color with
2/3.
Pressing
2/3 will switch
ILLUMI between red
or green and that status will be displayed (e.g.,
ILLUMI :GRN ).
Setting the rear output and sub-
woofer controller
This product’s rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (
Rear SP:FULL ) or subwoofer
( Rear SP:S.W ) connection. If you switch rear
output setting to the Rear SP:S.W , you can con-
nect a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL ).
When rear output are connected to full range
speakers (when
Rear SP:FULL is selected), you
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass
filter, phase) built-in
S.W Control:INT or the
auxiliary S.W Control:EXT .
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 34) or subwoofer output
(refer to page 33) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1 Press FUNCTION to select SW .
Press FUNCTION repeatedly until Rear SP
appears in the display.
2 Change the rear output setting with
5/∞.
Pressing
5/∞ will switch between
Rear SP
:FULL (full-range speaker) and Rear SP :S.W
(subwoofer) and that status will be displayed.
En 38
08
Section