Pioneer AVIC-Z1 - Manual (Page 179)

177
Ap
p
e
ndix
NA
V
I/
A
V
If system errors frequently occur
If system errors frequently occur and the power
to the navigation system turns off, an inappropri-
ate content may have been recorded in the mem-
ory or the hard disk drive. In such a case, the
normal operation may be restored by clearing the
setting values stored in the hard disk drive. For
the contents to be cleared, see the list presented
later.
➲ Chart for data deleted ➞ Page 176
1
Start the engine.
After a little time, the start-up screen comes
on for a few seconds.
2
Touch and hold the MAP button while the
start-up screen is displayed.
The Clear memory screen appears.
3
Touch [Reset].
4
Touch [Yes].
The setting values stored in the hard disk drive
return to the default or factory settings. After
that, the navigation opening screen appears.
Returning the navigation system
completely to the initial state
To return the entire navigation system to the
default or factory settings, initialize the naviga-
tion system in the following order:
1
Turn the ignition switch off.
2
Press the RESET button.
3
Start the engine.
After a little time, the start-up screen comes
on for a few seconds.
4
Touch and hold the MAP button while the
start-up screen is displayed.
The Clear memory screen appears.
5
Touch [Clear user information from hard
disk].
❒ This reset operation clears all music data
recorded in the music library. Note that the
cleared data cannot be restored.
6
Touch [Yes].
The user area in the hard disk drive is initial-
ized. After that, the navigation system restarts.
1 1
Method 1 Method 2 Method 3 Method 4
Audio functions
Music Library
(LIBRARY) Repeat, Random, Scan, and Pause set-
tings
✓ — ✓ ✓
Track data
— — — ✓
Play list — — — ✓
Last playback position
— — — ✓
XM Alert on/off for My Mix
✓ — ✓ ✓
FM Preset memory ✓ — — —
AM Preset memory ✓ — — —
TV Preset memory
✓ — — —
REAR
SCREEN Rear Screen setting
✓ — ✓ ✓
Others Picture Adjust ✓ — — —
Display Angle ✓ — — —
1. Press the RESET button on the hard-
ware.
2. Initialize the user data area on the hard
disk drive.
3. Clear the learned data in the sensor.