Setting up the unit, Where to use the unit, 1 unpack the unit and raise the backrest – Panasonic EP1080 User Manual

Page 8: Remove the top of the shipping container, Raise the backrest, 2 inspect contents of shipping container

Advertising
background image

7

English

SETTING UP THE UNIT

WHERE TO USE THE UNIT

Keep at least 3.9

(10 cm) away from the wall.

Approx. 76.8

(195 cm)

Approx. 13.8

(35 cm)

Width approx.

27.5

(70 cm)

Approx. 11.8

(30 cm)

Mat

Area where legrest
could touch the floor

Area where unit
touches the floor

Avoid places where the unit will be exposed to direct sunlight
for long periods of time or places where it will be exposed to
high temperatures, such as in front of a heater, etc., as this
can cause discoloration or hardening of the synthetic leather.
Placing a mat or cloth under the unit is recommended to
prevent floor damage. The size of the mat should be sufficient
[at least 47.2 in. × 27.5 in. (120 cm × 70 cm)] to cover the
areas where the unit touches and where the legrest could
touch the floor.
Set the unit near the outlet.

See Warning No. 11 and 12 on page 1.

1 UNPACK THE UNIT AND RAISE THE BACKREST

CAUTION

When raising the backrest, be careful not to cause hands or feet to become caught between the backrest and the
backrest latch or the backrest and the armrests.

Failure to follow this precaution may result in injury.

Check that there
is nothing
around the unit.

Backrest latch

1

Remove the top of the shipping container.

When packed for shipping the backrest is folded forward.

2

Remove the packing and cushioning
materials and take out all accessories.

3

Raise the backrest.

Do not connect the power cord to an electrical outlet during setup.
Hold the backrest with both hands and lift in the direction of the
arrow until it comes to a stop.
Be careful the power cord and controller are not caught in the
backrest.


2 INSPECT CONTENTS OF SHIPPING CONTAINER

Massage Lounger

Pillow

Back Cushion

Allen Key — 1

Attachment Screws — 8

Lock Switch Key — 1

The lock switch key has
been inserted in the
lock switch prior to
leaving the factory.

Armrests — 2

Advertising