PIONEERPOS AT Commands G24-LC - Manual (Page 120)

Call Control
3-56 G24-L AT Commands Reference Manual April 15, 2008
+COLP, Connected Line Identification Presentation
This command relates to the GSM supplementary service called COLP (Connected Line
Identification Presentation), which enables a calling subscriber to obtain the connected line
identity (COL) of the called party after setting up a mobile-originated call with the G24-L. For
example, after setting up a mobile-originated call to one number that is forwarded to another
number, the calling party will see the number of that third party.
When this command is enabled (and the called subscriber permits it), the following intermediate
result code is returned:
+COLP: <number>,<type>[,<subaddr>,<satype>[,<alpha>]].
Note: This command is activated when COLP is supported by the network.
NBR_SN_EXCEEDED 73
NBR_USER_EXCEEDED 74
Call Control by SIM Causes
NOT_ALLOWED_BY_CC 75
MODIFIED_TO_SS_BY_CC 76
MODIFIED_TO_CALL_BY_CC 77
CALL_MODIFIED_BY_CC 78
App. Cause
FDN_FAILURE 90
Command Type Syntax Response/Action Remarks
Set +COLP=<n> OK
+CME ERROR: <err>
The Set command enables/disables the
display of the COL at the TE on the
G24-L. It has no effect on the
execution of the COLR supplementary
service on the network. The value set
by this command is not retained after a
power cycle.
Read +COLP? +COLP: <n>,<m>
+CME ERROR: <err>
The Read command displays the status
of <n>. It also initiates a query of the
COLP service provision status and
displays <m>.
Test +COLP=? +COLP: (list of
supported <n>s)
+CME ERROR: <err>
The Test command displays the
supported values of <n>.
Table 3-30: CUSD Termination Cause Table Index (Cont.)
Termination Cause Index