PIONEERPOS AT Commands G24-LC - Manual (Page 175)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-111
If after aborting AT+CMGS command execution and before result of operation was
reported by G24-L, a second AT+CMGS command is executed, then the result of the
second AT+CMGS operation only will be reported by G24-L.
+MCSAT, Motorola Control SMS Alert Tone
This command enables/disables/exercises the SMS alert tone for an arriving SMS. It does not
apply on Cell Broadcast SMS.
The following table shows the +MCSAT parameters.
Command
Type
Syntax Response/Action Remarks
Set +MCSAT=<mode>
[,<dcs_mask>[,....]]
OK
or:
+CME ERROR: <err>
The Set command is used to:
• Suppress (mute) the voice notification
(alert tone) of a specific incoming SMS,
identified by the received <dcs_mask>s
property
• Enable voice notification (alert tone) of
all incoming SMS events
• Activate the current alert tone for an
incoming SMS event
Read +MCSAT? +MCSAT:
<mode>[,<dcs_mask>[,
....]]
OK
or:
+CME ERROR: <err>
The Read command returns the current
<mode> and current <dcs_mask>s.
Test +MCSAT=? +MCSAT: (list of
supported <mode>s)
OK
or:
+CME ERROR: <err>
The Test command returns the possible
<mode> values.
Table 3-71: +MCSAT Parameters
<Parameter> Description
<mode> 0 Suppress alert tone
1 Enable alert tone
2 Play alert tone
The default value at power-up is 1.
<dcs_mask> SMS data coding-scheme mask. The format is an 8-bit information parameter. Each
bit contains 0, 1, or X (ASCII character):
0
Condition is met if the arriving SMS includes dcs with 0 in this position
1 Condition is met if the arriving SMS includes dcs with 1 in this position
X or x This bit is ignored from the dcs of the arriving SMS