PIONEERPOS AT Commands G24-LC - Manual (Page 189)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-125
+CPOL, Preferred Operators
This command is used to edit the list of preferred network operators located in the SIM card.
Command
Type Syntax Response/Action Remarks
Set AT+CPOL=[<index>]
[,<format>[,
<oper>]]
OK
or:
+CME ERROR: <err>
The Set command writes an entry in
the list of preferred operators.
Note: The G24-L may also update
this list automatically when
new networks are selected.
Read AT+CPOL? +CPOL:
<index1>,<format>,<oper1>
[<CR><LF>+CPOL:
<index2>,<format>,<oper2>
[...]]
OK
or:
+CME ERROR: <err>
The Read command displays all the
preferred operators that have been
entered into the list.
Test AT+CPOL=? +CPOL: (list of supported
<index>s),(list of supported
<format>s)
OK
or:
+CME ERROR: <err>
* Index range is SIM
dependent
The Test command displays the
entire index range supported by the
SIM.