PIONEERPOS AT Commands G24-LC - Manual (Page 190)

Network
3-126 G24-L AT Commands Reference Manual April 15, 2008
The following table shows the +CPOL parameters.
Note: To delete an entry from the list, enter an <index> without an <oper>.
If an <oper> is entered without an <index>, the <oper> is placed in the next free location
in the list.
To change the format of <oper> displayed with the Read command, enter a <format>.
User is prevented to edit index No. 0. This is the HOME PLMN and is not stored in the
SIM preferred list element file.
When entering a new item with an <index> to a full list, the G24-L deletes the last item,
stores the new item in the requested entry, and shifts the rest of the list down.
When entering a new item without an <index> to a full list, the G24-L replaces the last
entry with the new item.
+MFS, Motorola Frequency of Search
This command is used to determine how long the G24-L waits before attempting to reregister
after a registration attempt has failed and the G24-L is not registered. The available settings are
Slow Search, Medium Search, Fast Search or Continuous Search.
See Table 3-80, “+MFS Parameters” , for the minimum interval lengths for every frequency of
search. The interval between attempts can vary, depending on the number of operators displayed
in the preferred operator list.
This command sets or reads Frequency of Search and Search mode settings. After a Set command
has been executed, new Frequency of Search and Search mode values are active.
Table 3-79: +CPOL Parameters
<Parameter> Description
<indexn> Order number of network operator in the SIM preferred operator list
<format> Defines the <oper> format:
0
Long alphanumeric format (up to 16 characters)
1 Short alphanumeric format (up to 8 characters)
2 Numeric (default)
<oper> Name of the network operator