PIONEERPOS AT Commands G24-LC - Manual (Page 223)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-159
The following table shows the +CRSL parameters.
Example
AT+CRSL?
+CRSL: 7
OK
AT+CRSL=?
+CRSL: (0-7)
OK
AT+CRSL=5
OK
+CLVL, Loudspeaker Volume
This command sets the volume of the internal loudspeaker (which also affects the key feedback
tone) of the G24-L.
This command is applicable for Analog and Digital modes.
Note: The +CLVL command does not control the alert speaker.
In this command, the new value remains after power cycle.
The +CLVL command can be used even when the SIM is not inserted.
Table 3-101: +CRSL Parameters
<Parameter> Description
<level> 0 Mute
1-7 Ringer sound level (1 is lowest; 7 is default after flex)
Command Type Syntax Response/Action Remarks
Set +CLVL=<level> OK
+CME ERROR: <err>
The Set command sets the internal
loudspeaker volume level.
Read +CLVL? +CLVL: <level>
+CME ERROR: <err>
The Read command displays the
current internal loudspeaker volume
setting.
Test +CLVL=? +CLVL: (list of
supported <level>s)
+CME ERROR: <err>
The Test command displays the
possible loudspeaker volume settings.