Cmut, mute/unmute currently active microphone path, Clvl parameters -160, Cmut parameters -160 – PIONEERPOS AT Commands G24-LC User Manual
Page 224
Audio
3-160
G24-L AT Commands Reference Manual
April 15, 2008
The following table shows the +CLVL parameters.
Example
AT+CLVL?
+CLVL: 7
OK
AT+CLVL=?
+CLVL: (0-7)
OK
AT+CLVL=3
OK
+CMUT, Mute/Unmute Currently Active Microphone Path
This command is used to mute/unmute the currently active microphone path by overriding the
current mute state.
The following table shows the +CMUT parameters.
Table 3-102: +CLVL Parameters
<Parameter>
Description
<level>
0-7
Manufacturer-specific volume range. 0 is lowest volume (not mute).
The default value is 7 after flex.
Command Type
Syntax
Response/Action
Remarks
Set
+CMUT=<state>
OK
or:
+CME ERROR: <err>
The Set command enables/disables
uplink voice muting during a voice
call.
Read
+CMUT?
+CMUT: <state>
OK
The Read command returns the current
uplink voice mute/unmute state.
Test
+CMUT=?
+CMUT: (list of
supported <state>s)
OK
The Test command returns the possible
<state> values.
Table 3-103: +CMUT Parameters
<Parameter>
Description
<n>
0
Unmute microphone path
1
Mute microphone path